In this Dell laptop tutorial we are going to show you how to install and replace the USB/SD Card IO Board on your Dell Inspiron 16 (7610) laptop. These installation instructions have been made into 4 easy to follow printable steps. We have also created a video tutorial that shows you how to install your Dell Inspiron 16 (7610) USB/SD Card IO Board.
Before you begin
Dell repair manual service precautions
Tools needed for this laptop repair
- 1 x small phillips head screwdriver
- 1 x small plastic scribe
|
DIY Discount - Parts-People.com offers 5% off to all DO-IT-YOURSELFERS!
Use this coupon code to save 5% off these parts DIYM514
|
Video tutorial repair manual
Installation and Removal Instructions
Dell Inspiron 16 (7610) USB/SD Card IO Board
![Before you begin: If you need help at any point, you can always contact Parts-People Repair Department for help with your diagnosis or repair.](https://www.parts-people.com/blog/wp-content/uploads/2023/07/LAPTOP-SERVICE-BLOG-THUMBNAIL-300x169.jpg)
![Before you begin: If you need help at any point, you can always contact Parts-People Repair Department for help with your diagnosis or repair.](https://www.parts-people.com/blog/wp-content/uploads/2023/07/LAPTOP-SERVICE-BLOG-THUMBNAIL-300x169.jpg)
Step 1
- Before you begin: If you need help at any point, you can always contact Parts-People Repair Department for help with your diagnosis or repair.
![Use a Phillips Screwdriver to unscrew the](https://www.parts-people.com/blog/wp-content/uploads/2023/07/bottombasecover1-1-300x169.jpg)
![Use a Phillips Screwdriver to unscrew the](https://www.parts-people.com/blog/wp-content/uploads/2023/07/bottombasecover1-1-300x169.jpg)
Step 2
- Use a Phillips Screwdriver to unscrew the Bottom Base Cover (7 x M2 x 4mm) (2 x captive screws).
- Use a Plastic Scribe to pry apart and remove the Bottom Base Cover.
![]() ![]() ![]() ![]() ![]() ![]() |
![Disconnect the Battery.](https://www.parts-people.com/blog/wp-content/uploads/2023/07/battery2-2-300x169.jpg)
![Disconnect the Battery.](https://www.parts-people.com/blog/wp-content/uploads/2023/07/battery2-2-300x169.jpg)
Step 3
- Disconnect the Battery.
![Unscrew the USB/SD Card IO Board (2 x](https://www.parts-people.com/blog/wp-content/uploads/2023/07/usdsdioboard1-300x169.jpg)
![Unscrew the USB/SD Card IO Board (2 x](https://www.parts-people.com/blog/wp-content/uploads/2023/07/usdsdioboard1-300x169.jpg)
Step 4
- Unscrew the USB/SD Card IO Board (2 x M2 x 3mm).
- Unclip tabs (in the direction indicated) and then disconnect the USB/SD Card IO Board.
- ***FOLLOW THESE STEPS IN REVERSE TO REINSTALL YOUR PART.
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() |